Atm Bulk-Config Modify - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

atm bulk-config modify

Syntax
Release Information
Description
Options
Mode
160
atm bulk-config bulkConfigName modify vc-range vpiStart vpiEnd vciStart vciEnd
Command introduced before JunosE Release 7.1.0.
Modifies the VC subrange values for the specified bulk configuration VC range. If the new
subrange encompasses previously configured subranges within that range, those
subranges are merged into the new one, freeing subrange resources. There is no no
version.
bulkConfigName—Name of the VC range; string of up to 80 characters
vpiStart—Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
vpiEnd—Ending virtual path identifier (inclusive) of the VC subrange you are configuring
vciStart—Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
vciEnd—Ending virtual circuit identifier (inclusive) of the VC subrange you are configuring
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.