Address Authentication Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

address authentication mode

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
address { ipAddress | unnumbered interfaceType interfaceSpecifier }
authentication mode { text | md5 keyID }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ]
authentication mode
Command introduced before JunosE Release 7.1.0.
Specifies the type of authentication used on this interface. The no version removes
authentication from the interface. Supported only in RIP version 2. Authentication is
disabled by default.
ipAddress—Address of IP interface where RIP will be run
unnumbered—Specifies RIP will be run on an unnumbered interface
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
text—Simple text password is sent with each RIP message. If the password is not
possessed by neighbors, the message is rejected.
md5—MD5 message-digest algorithms are used to encrypt and compress the RIP
message.
keyID—Number identifying the MD5 key. Neighbors must share the MD5 key to decrypt
the message and encrypt the response.
Address Family Configuration, Router Configuration
Chapter 2: A Commands
89