Currently, the S7900E series Ethernet switches do not support configuring the ospfv3 timer dead
command on a loopback interface.
Related commands: ospfv3 timer hello.
Examples
# Configure the OSPFv3 neighbor dead time as 80 seconds for the interface in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer dead 80 instance 1
ospfv3 timer hello
Syntax
ospfv3 timer hello seconds [ instance instance-id ]
undo ospfv3 timer hello [ instance instance-id ]
View
Interface view
Default Level
2: System level
Parameters
seconds: Interval between hello packets, ranging from 1 to 65535.
instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.
Description
Use the ospfv3 timer hello command to configure the hello interval for an interface that belongs to an
instance.
Use the undo ospfv3 timer hello command to restore the default .
By default, the hello interval is 10 seconds for P2P and Broadcast interfaces, and is not supported on
the P2MP or NBMA interfaces at present.
Currently, the S7900E series Ethernet switches do not support configuring the ospfv3 timer hello
command on a loopback interface.
Related commands: ospfv3 timer dead.
1-33