Rip Mib-Binding; Rip Output - 3Com S7906E Command Reference Manual

rip mib-binding

Syntax
rip mib-binding process-id
undo rip mib-binding
View
System view
Default Level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the rip mib-binding command to bind MIB operations with a specified RIP process, so that the RIP
process can receive SNMP requests.
Use the undo rip mib-binding command to restore the default.
By default, MIB operations are bound to RIP process 1, that is, RIP process 1 is enabled to receive
SNMP requests.
Examples
# Configure RIP 100 to accept SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding

rip output

Syntax
rip output
undo rip output
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the rip output command to enable the interface to send RIP messages.
1-22