Ip Rpf-Route-Static - 3Com S7906E Command Reference Manual

Route selection rule: preference-preferred
Load splitting rule: disable
Table 1-6 display multicast rpf-info command output description
Field
RPF information about source
192.168.1.55
RPF interface
RPF neighbor
Referenced route/mask
Referenced route type
Route selection rule
Load splitting rule

ip rpf-route-static

Syntax
ip rpf-route-static [ vpn-instance vpn-instance-name ] source-address { mask | mask-length }
[ protocol [ process-id ] ] [ route-policy policy-name ] { rpf-nbr-address | interface-type
interface-number } [ preference preference ] [ order order-number ]
undo ip rpf-route-static [ vpn-instance vpn-instance-name ] source-address { mask | mask-length }
[ protocol [ process-id ] ] [ route-policy policy-name ]
View
System view
Default Level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies a VPN instance. A VPN instance name is a case sensitive
string of up to 31 characters and must not contain any space..
source-address: Multicast source address.
mask: Mask of the multicast source address.
mask-length: Mask length of the multicast source address, in the range of 0 to 32.
protocol: Routing protocol, which can have any of the following values:
Information of the RPF path to multicast source 192.168.1.55
RPF interface
IP address of the RPF neighbor
Referenced route and its mask length
Type of the referenced route, which can be any of the following:
igp: unicast route (IGP)
egp: unicast route (BGP)
unicast (direct): unicast route (directly connected)
unicast: other unicast route (such as unicast static route)
mbgp: MBGP route
multicast static: multicast static route
Rule for RPF route selection, which can be based on the
preference of the routing protocol or based on the longest match
on the destination address
Status of the load splitting rule (enabled/disabled)
1-9
Description