Ip Route-Static Default-Preference - 3Com S7906E Command Reference Manual

[Sysname] ip route-static vpn-instance vpn1 1.1.1.1 16 vpn-instance vpn1 1.1.1.2

ip route-static default-preference

Syntax
ip route-static default-preference default-preference-value
undo ip route-static default-preference
View
System view
Default Level
2: System level
Parameters
default-preference-value: Default preference for static routes, which is in the range of 1 to 255.
Description
Use the ip route-static default-preference command to configure the default preference for static
routes.
Use the undo ip route-static default-preference command to restore the default.
By default, the default preference of static routes is 60.
Note that:
If no preference is specified when configuring a static route, the default preference is used.
When the default preference is re-configured, it applies to newly added static routes only.
Related commands: display ip routing-table, ip route-static.
Examples
# Set the default preference of static routes to 120.
<Sysname> system-view
[Sysname] ip route-static default-preference 120
1-4