display mld ssm-mapping group
Syntax
display mld ssm-mapping group [ ipv6-group-address | interface interface-type interface-number ]
[ verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
ipv6-group-address: Specifies a multicast group by its IPv6 address, in the range of FFxy::/16
(excluding FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimal
number ranging from 0 to F.
interface-type interface-number: Specifies an interface by its type and number.
verbose: Displays the detailed multicast group information created based on the configured MLD SSM
mappings.
Description
Use the display mld ssm-mapping group command to view the multicast group information created
based on the configured MLD SSM mappings.
Note that:
If you do not specify an IPv6 multicast group, this command will display the information of all IPv6
multicast groups created based on the configured MLD SSM mappings.
If you do not specify an interface, this command will display the multicast group information created
based on the configured MLD SSM mappings on all interfaces.
Examples
# View the detailed information of IPv6 multicast group FF3E::101 created based on the configured
MLD SSM mappings on all interfaces.
<Sysname> display mld ssm-mapping group ff3e::101 verbose
Interface group report information
Vlan-interface1(FE80::101):
Total 1 MLD SSM-mapping Group reported
Group: FF3E::101
Uptime: 00:01:46
Expires: off
Last reporter: FE80::10
Group mode: include
Source list(Total 1 source):
Source: 30::1
Uptime: 00:01:46
Expires: 00:02:34
Last-listener-query-counter: 0
1-8