Dhcp-Snooping Information Circuit-Id Format-Type; Dhcp-Snooping Information Circuit-Id String - 3Com S7906E Command Reference Manual

Related commands: display dhcp-snooping.
Examples
# Enable DHCP snooping.
<Sysname> system-view
[Sysname] dhcp-snooping

dhcp-snooping information circuit-id format-type

Syntax
dhcp-snooping information circuit-id format-type { ascii | hex }
undo dhcp-snooping information circuit-id format-type
View
Ethernet port view
Default Level
2: System level
Parameters
ascii: Specifies the code type for the circuit ID sub-option as ascii.
hex: Specifies the code type for the circuit ID sub-option as hex.
Description
Use the dhcp-snooping information circuit-id format-type command to configure the code type for
the non-user-defined circuit ID sub-option.
Use the undo dhcp-snooping information circuit-id format-type command to restore the default.
By default, the code type for the circuit ID sub-option depends on the padding format of Option 82. Each
field has its own code type.
Note that:
This command applies to configuring the non-user-defined circuit ID sub-option only. After you
configure the padding content for the circuit ID sub-option using the dhcp-snooping information
circuit-id string command, ASCII is adopted as the code type.
Examples
# Configure the padding format for the non-user-defined circuit ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dhcp-snooping information circuit-id format-type ascii

dhcp-snooping information circuit-id string

Syntax
dhcp-snooping information [ vlan vlan-id ] circuit-id string circuit-id
undo dhcp-snooping information [ vlan vlan-id ] circuit-id string
4-2