Preference (Ipv6 Mbgp Address Family View) - 3Com S7906E Command Reference Manual

By default, no route policy is applied to the routes incoming from or outgoing to an IPv6 MBGP peer or
peer group.
The if-match interface clause in the route policy referenced by the peer route-policy command will
not be applied.
Refer to Route Policy Commands in the IP Routing Volume for related information.
Examples
# Apply the route policy test-policy to routes received from the IPv6 MBGP peer group test.
<Sysname> system-view
[Sysname] route-policy test-policy permit node 10
[Sysname-route-policy] if-match cost 10
[Sysname-route-policy] apply cost 65535
[Sysname-route-policy] quit
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test route-policy test-policy import

preference (IPv6 MBGP address family view)

Syntax
preference {
route-policy-name }
undo preference
View
IPv6 MBGP address family view
Default Level
2: System level
Parameters
external-preference: Preference of IPv6 multicast eBGP routes, in the range 1 to 255. An IPv6 multicast
eBGP route is learned from an IPv6 multicast eBGP peer.
internal-preference: Preference of IPv6 multicast iBGP routes, in the range 1 to 255. An IPv6 multicast
iBGP route is learned from an IPv6 multicast iBGP peer.
local-preference: Preference of locally generated IPv6 MBGP routes, in the range 1 to 255.
route-policy-name: Route policy name, a string of 1 to 19 characters. Using a route policy, you can
configure the preferences for the routes that match the filtering conditions. As for the unmatched routes,
the default preferences are adopted.
external-preference internal-preference local-preference
1-42
| route-policy