Mld Require-Router-Alert - 3Com S7906E Command Reference Manual

Use the undo mld max-response-time command to restore the default configuration.
By default, the maximum response delay for MLD general query messages is 10 seconds.
The maximum response delay determines the time which the device takes to detect directly attached
group members in the LAN.
Related commands: max-response-time, mld timer other-querier-present, display mld interface.
Examples
# Set the maximum response delay for MLD general query messages to 8 seconds on VLAN-interface
100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld max-response-time 8

mld require-router-alert

Syntax
mld require-router-alert
undo mld require-router-alert
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the mld require-router-alert command to configure the interface to discard MLD messages
without the Router-Alert option.
Use the undo mld require-router-alert command to restore the default configuration.
By default, the device does not check the Router-Alert option, that is, it forwards all received MLD
messages to the upper layer protocol for processing.
Related commands: require-router-alert, mld send-router-alert.
Examples
# Configure VLAN-interface 100 to discard MLD messages without the Router-Alert option.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld require-router-alert
1-14