Robust-Count (Mld View) - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
all: The first all specifies to clear IPv6 multicast group information created based on the configured MLD
SSM mappings on all interfaces, while the second all specifies to clear all IPv6 multicast group
information created based on the configured MLD SSM mappings..
interface-type interface-number: Specifies an interface by its type and number.
ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address, in the form of FFxy::/16,
where x and y represent any hexadecimal number ranging from 0 to F.
ipv6-source-address: Specifies a multicast source by its IPv6 address.
prefix-length: Prefix length of the multicast source or multicast group address. For a multicast source
address, this argument has an effective value range of 0 to 128; for a multicast group address, it has an
effective value range of 8 to 128. The system default is 128 in both cases.
Description
Use the reset mld ssm-mapping group command to clear IPv6 multicast group information created
based on the configured MLD SSM mappings.
Related commands: display mld ssm-mapping group.
Examples
# Clear all IPv6 multicast group information created based on the configured MLD SSM mappings on all
interfaces.
<Sysname> reset mld ssm-mapping group all

robust-count (MLD view)

Syntax
robust-count robust-value
undo robust-count
View
MLD view
Default Level
2: System level
Parameters
robust-value: MLD querier robustness variable, with an effective range of 2 to 5.
Description
Use the robust-count command to configure the MLD querier robustness variable globally.
Use the undo robust-count command to restore the system default.
By default, the MLD querier robustness variable is 2.
1-24