Mld Enable - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the mld command to enter MLD view.
Use the undo mld command to remove the configurations made in MLD view.
Note that this command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: mld enable; multicast ipv6 routing-enable in IPv6 Multicast Routing and
Forwarding Commands in the IP Multicast Volume.
Examples
# Enable IPv6 multicast routing and enter MLD view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] mld
[Sysname-mld]

mld enable

Syntax
mld enable
undo mld enable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the mld enable command to enable MLD on the current interface.
Use the undo mld enable command to disable MLD on the current interface.
By default, MLD is disabled on the current interface.
Note that:
This command can take effect only after IPv6 multicast routing is enabled on the device.
Other MLD configurations performed on the interface can take effect only after MLD is enabled on
the interface.
Related commands: mld; multicast ipv6 routing-table in IPv6 Multicast Routing and Forwarding
Commands in the IP Multicast Volume.
1-11