Ospf Authentication-Mode - 3Com S7906E Command Reference Manual

[Sysname-ospf-100]

ospf authentication-mode

Syntax
For MD5/HMAC-MD5 authentication:
ospf authentication-mode { md5 | hmac-md5 } key-id [ plain | cipher ] password
undo ospf authentication-mode { md5 | hmac-md5 } key-id
For simple authentication:
ospf authentication-mode simple [ plain | cipher ] password
undo ospf authentication-mode simple
View
Interface view
Default Level
2: System level
Parameters
md5: MD5 authentication.
hmac-md5: HMAC-MD5 authentication.
simple: Simple authentication.
key-id: Authentication key ID, in the range 1 to 255.
plain | cipher: Plain or cipher password. If plain is specified, only plain password is supported and
displayed upon displaying the configuration file. If cipher is specified, both plain and cipher are
supported, but only cipher password is displayed when displaying the configuration file. If no keyword is
specified, the cipher type is the default for the MD5/HMAC-MD5 authentication mode, and the plain type
is the default for the simple authentication mode.
password: Password. Simple authentication: For plain type password, a plain password is a string of up
to 8 characters; for cipher type password, a plain password is a string of up to 8 characters, and a cipher
password is a string of up to 24 characters. MD5/HMAC-MD5 authentication: For plain type password, a
plain password is a string of up to16 characters; for cipher type password, a plain password is a string of
up to 16 characters, and a cipher password is a string of up to 24 characters.
Description
Use the ospf authentication-mode command to set the authentication mode and key ID on an
interface.
Use the undo ospf authentication-mode command to remove specified configuration.
By default, no authentication is available on an interface.
Interfaces attached to the same network segment must have the same authentication password and
mode.
This configuration is not supported on the null interface.
Related commands: authentication-mode.
1-46