Igmp-Snooping Group-Limit - 3Com S7906E Command Reference Manual

Description
Use the igmp-snooping general-query source-ip command to configure the source address of IGMP
general queries.
Use the undo igmp-snooping general-query source-ip command to restore the default
configuration.
By default, the source IP address of IGMP general queries is 0.0.0.0.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# In VLAN 2, enable IGMP Snooping and specify 10.1.1.1 as the source IP address of IGMP general
queries.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] qui
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1

igmp-snooping group-limit

Syntax
igmp-snooping group-limit limit [ vlan vlan-list ]
undo igmp-snooping group-limit [ vlan vlan-list ]
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
limit: Maximum number of multicast groups that can be joined on a port, in the range 1 to 1000.
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the igmp-snooping group-limit command to configure the maximum number of multicast groups
that can be joined on a port.
Use the undo igmp-snooping group-limit command to restore the default setting.
The default setting depends on the specific product model.
Note that:
1-11