Source-Deny (Igmp-Snooping View) - 3Com S7906E Command Reference Manual

View
IGMP-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.
Description
Use the router-aging-time command to configure the aging time of dynamic router ports globally.
Use the undo router-aging-time command to restore the default setting.
By default, the aging time of dynamic router ports is 105 seconds.
This command works only on IGMP Snooping–enabled VLANs, but not on VLANs with IGMP enabled
on their VLAN interfaces.
Related commands: igmp-snooping router-aging-time.
Examples
# Set the aging time of dynamic router ports globally to 100 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] router-aging-time 100

source-deny (IGMP-Snooping view)

Syntax
source-deny port interface-list
undo source-deny port interface-list
View
IGMP-Snooping view
Default Level
2: System level
Parameters
interface-list: Specifies one or multiple ports. You can provide up to ten port lists, by each of which you
can specify an individual port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end
interface number must be greater than the start interface number.
Description
Use the source-deny command to enable multicast source port filtering so that all multicast data
packets are blocked.
Use the undo source-deny command to disable multicast source port filtering.
1-28