Overflow-Replace (Igmp-Snooping View) - 3Com S7906E Command Reference Manual

Description
Use the max-response-time command to configure the maximum response time to IGMP general
queries globally.
Use the undo max-response-time command to restore the default value.
This command works only on IGMP Snooping–enabled VLANs, but not on VLANs with IGMP enabled
on their VLAN interfaces.
Related commands: igmp-snooping max-response-time, igmp-snooping query-interval.
Examples
# Set the maximum response time to IGMP general queries globally to 5 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] max-response-time 5

overflow-replace (IGMP-Snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
IGMP-Snooping view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the overflow-replace command to enable the multicast group replacement function globally.
Use the undo overflow-replace command to disable the multicast group replacement function
globally.
By default, the multicast group replacement function is disabled.
Note that:
This command works on both IGMP Snooping–enabled VLANs and VLANs with IGMP enabled on
their VLAN interfaces.
If you do not specify any VLAN, the command will take effect for all VLANs; if you specify a VLAN or
multiple VLANs, the command will take effect for the specified VLAN(s) only.
Related commands: igmp-snooping overflow-replace.
1-25