3Com S7906E Command Reference Manual page 1430

Default Level
1: Monitor level
Parameters
verbose: Displays detailed routing table information, including both active and inactive routes. With this
argument absent, the command displays brief information about active IPv6 MBGP routes only.
Description
Use the display ipv6 multicast routing-table command to display the IPv6 MBGP routing table.
There are active and inactive routes in the IPv6 MBGP routing table. Active routes are the optimal
routes used for RPF check.
Examples
# Display brief IPv6 MBGP routing table information.
<Sysname> display ipv6 multicast routing-table
Routing Table :
Destinations : 1
Destination :
NextHop : ::1
Interface : InLoopBack0
State : Active NoAdv
Tunnel ID : 0x0
Age : 156sec
Table 1-1 display ipv6 multicast routing-table command output description
Field
Destination
PrefixLength
Nexthop
Preference
Interface
Protocol
State
Cost
Tunnel ID
Label
Age
# Display detailed IPv6 MBGP routing table information.
<Sysname> display ipv6 multicast routing-table verbose
Routing Table :
Routes : 1
::1
Destination IPv6 address
Prefix length of the address
Next hop IP address
Route preference
Outbound interface
Routing protocol
Status of the route, which could be Active, Inactive, Adv, or NoAdv
Route cost
Tunnel ID
Label
Time elapsed since the route was generated
PrefixLength : 128
Preference : 0
Protocol
Cost
Label
Description
1-8
: Direct
: 0
: NULL