Display Ip Routing-Table Protocol - 3Com S7906E Command Reference Manual

This command is intended for the follow-up display of routing policies. If the specified prefix list is not
configured, detailed information about all routes (with the verbose keyword) or brief information about
all active routes (without the verbose keyword) is displayed.
Examples
# Configure a prefix list named test, permitting routes with a prefix of 2.2.2.0 and a mask length
between 24 and 32.
<Sysname> system-view
[Sysname] ip ip-prefix test permit 2.2.2.0 24 less-equal 32
# Display brief information about active routes permitted by the prefix list test.
[Sysname] display ip routing-table ip-prefix test
Routes Matched by Prefix list : test
Summary Count : 2
Destination/Mask
2.2.2.0/24
2.2.2.1/32
For detailed description of the above output, see
# Display detailed information about both active and inactive routes permitted by IP prefix list test.
[Sysname] display ip routing-table ip-prefix test verbose
Routes Matched by Prefix list
Summary Count : 2
Destination: 2.2.2.0/24
Protocol: Direct
Preference: 0
NextHop: 2.2.2.1
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
State: Active Adv
Tag: 0
Destination: 2.2.2.1/32
Protocol: Direct
Preference: 0
NextHop: 127.0.0.1
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
State: Active NoAdv
Tag: 0
For detailed description of the above output, see

display ip routing-table protocol

Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
Proto Pre Cost
Direct 0 0
Direct 0 0
test :
Process ID: 0
Process ID: 0
NextHop Interface
2.2.2.1 Vlan2
127.0.0.1 InLoop0
Table 1-1.
Cost: 0
Interface: Vlan2
Neighbour: 0.0.0.0
Label: NULL
Age: 00h20m52s
Cost: 0
Interface: InLoop0
Neighbour: 0.0.0.0
Label: NULL
Age: 00h20m52s
Table 1-2.
1-10