Pim Ipv6 Timer Join-Prune; Pim Ipv6 Triggered-Hello-Delay - 3Com S7906E Command Reference Manual

[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer hello 40

pim ipv6 timer join-prune

Syntax
pim ipv6 timer join-prune interval
undo pim ipv6 timer join-prune
View
Interface view
Default Level
2: System level
Parameters
interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the pim ipv6 timer join-prune command to configure on the current interface the interval at which
join/prune messages are sent.
Use the undo pim ipv6 timer join-prune command to restore the system default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer join-prune 80

pim ipv6 triggered-hello-delay

Syntax
pim ipv6 triggered-hello-delay interval
undo pim ipv6 trigged-hello-delay
View
Interface view
Default Level
2: System level
Parameters
interval: Maximum delay in seconds between hello messages, with an effective range of 1 to 5.
1-38