Mld-Snooping Static-Router-Port - 3Com S7906E Command Reference Manual

Note that:
The source-ip ipv6-source-address option in the command is meaningful only for MLD Snooping
version 2. If MLD Snooping version 1 is running, although you can include source-ip
ipv6-source-address in your command, the simulated host responses with only an MLDv1 report
when receiving a query message.
If configured in Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect
only if the interface belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Examples
# Configure Ethernet 2/0/1 in VLAN 2 to be a static member port for (2002::22, FF3E::101).
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2
[Sysname-vlan2] quit
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] mld-snooping static-group ff3e::101 source-ip 2002::22 vlan 2

mld-snooping static-router-port

Syntax
mld-snooping static-router-port vlan vlan-id
undo mld-snooping static-router-port vlan vlan-id
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where
vlan-id is in the range of 1 to 4094.
Description
Use the mld-snooping static-router-port command to configure the current port(s) as static router
port(s).
Use the undo mld-snooping static-router-port command to restore the system default.
By default, no ports are static router ports.
Note that:
This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on
their VLAN interfaces.
1-22