Filter-Policy Export (Ospfv3 View) - 3Com S7906E Command Reference Manual

Transmit Delay
State
Timer intervals configured, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Hello due in 00:00:02
Adjacency state

filter-policy export (OSPFv3 view)

Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } export [ isisv6 process-id | ospfv3
process-id | ripng process-id | bgp4+ | direct | static ]
undo filter-policy export [ isisv6 process-id | ospfv3 process-id | ripng process-id | bgp4+ | direct |
static ]
View
OSPFv3 view
Default Level
2: System level
Parameters
acl6-number: Specifies the ACL6 number, ranging from 2000 to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list, a string of up to 19 characters.
isisv6 process-id: Specifies to filter the routes of an IPv6-IS-IS process, which is in the range of 1 to
65535.
ospfv3 process-id: Specifies to filter the routes of an OSPFv3 process, which is in the range of 1 to
65535.
ripng process-id: Specifies to filter the routes of a RIPng process, which in the range of 1 to 65535.
bgp4+: Specifies to filter BGP4+ routes.
direct: Specifies to filter direct routes.
static: Specifies to filter static routes.
Description
Use the filter-policy export command to filter redistributed routes.
Use the undo filter-policy export command to remove the configuration.
If no protocol is specified, all redistributed routes will be filtered.
By default, IPv6 OSPFv3 does not filter redistributed routes.
Field
1-23
Description
Transmit delay of sending LSAs
Interface state
Timer intervals in seconds, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Send hello packets in 2 seconds.
Adjacency state