Isis Circuit-Type P2P - 3Com S7906E Command Reference Manual

View
Interface view
Default Level
2: System level
Parameters
level-1: Sets the circuit level to Level-1.
level-1-2: Sets the circuit level to Level-1-2.
level-2: Sets the circuit level to Level-2.
Description
Use the isis circuit-level command to set the circuit level for the interface.
Use the undo isis circuit-level command to restore the default.
An interface can establish either the Level-1 or Level-2 adjacency by default.
Note that:
For a Level-1 (Level-2) router, the circuit level can only be Level-1 (Level-2). For a Level-1-2 router, you
need to specify a circuit level for a specific interface to form only the specified level neighbor
relationship.
Related commands: is-level.
Examples
# VLAN-interface 10 is connected to a non backbone router in the same area. Configure the circuit level
of VLAN-interface 10 as Level-1 to prevent sending and receiving Level-2 Hello packets.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis enable
[Sysname-Vlan-interface10] isis circuit-level level-1

isis circuit-type p2p

Syntax
isis circuit-type p2p
undo isis circuit-type
View
Interface view
Default Level
2: System level
Parameters
None
1-37