Register-Suppression-Timeout (Ipv6 Pim View) - 3Com S7906E Command Reference Manual

View
IPv6 PIM view
Default Level
2: System level
Parameters
acl6-number: Advanced IPv6 ACL number, in the range of 3000 to 3999. Only register messages that
match the permit statement of the IPv6 ACL can be accepted by the RP.
Description
Use the register-policy command to configure an IPv6 ACL rule to filter register messages.
Use the undo register-policy command to remove the configured register filtering rule.
By default, no register filtering rule is configured.
Related commands: register-suppression-timeout.
Examples
# Configure a register filtering policy on the RP so that the RP will accept only those register messages
from IPv6 multicast sources on the 3:1::/64 subnet for IPv6 multicast groups on the FF0E:13::/64
subnet.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule permit ipv6 source 3:1:: 64 destination ff0e:13:: 64
[Sysname-acl6-adv-3000] quit
[Sysname] pim ipv6
[Sysname-pim6] register-policy 3000

register-suppression-timeout (IPv6 PIM view)

Syntax
register-suppression-timeout interval
undo register-suppression-timeout
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval: Register suppression time in seconds, in the range of 1 to 3,600.
Description
Use the register-suppression-timeout command to configure the register suppression time.
Use the undo register-suppression-timeout command to restore the system default.
1-40