Host-Aging-Time (Mld-Snooping View); Last-Listener-Query-Interval (Mld-Snooping View) - 3Com S7906E Command Reference Manual

If the specified IPv6 ACL does not exist or the ACL rule is null, all IPv6 multicast groups will be
filtered out.
You can configure different IPv6 ACL rules for each port in different VLANs; for a given VLAN, a
newly configured IPv6 ACL rule will override the existing one.
Related commands: mld-snooping group-policy.
Examples
# Apply ACL 2000 as an IPv6 multicast group filter in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] group-policy 2000 vlan 2

host-aging-time (MLD-Snooping view)

Syntax
host-aging-time interval
undo host-aging-time
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in units of seconds. The effective range is 200 to 1,000.
Description
Use the host-aging-time command to configure the aging time of dynamic member ports globally.
Use the undo host-aging-time command to restore the default setting.
By default, the aging time of dynamic member ports is 260 seconds.
This command works only on MLD Snooping–enabled VLANs, but not on VLANs with MLD enabled on
their VLAN interfaces.
Related commands: mld-snooping host-aging-time.
Examples
# Set the aging time of dynamic member ports globally to 300 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] host-aging-time 300

last-listener-query-interval (MLD-Snooping view)

Syntax
last-listener-query-interval interval
1-6