Pim Ipv6 State-Refresh-Capable; Pim Ipv6 Timer Graft-Retry - 3Com S7906E Command Reference Manual

By default, IPv6 PIM-SM is disabled.
Note that this command can take effect only after IPv6 multicast routing is enabled on the device.
Related commands: pim ipv6 dm; multicast ipv6 routing-table in the IPv6 Multicast Routing and
Forwarding Commands in the IP Multicast Volume.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 sm

pim ipv6 state-refresh-capable

Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the pim ipv6 state-refresh-capable command to enable the state fresh feature on the interface.
Use the undo pim ipv6 state-refresh-capable command to disable the state fresh feature.
By default, the state refresh feature is enabled.
Related commands: state-refresh-interval, state-refresh-rate-limit, state-refresh-hoplimit.
Examples
# Disable state refresh on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] undo pim ipv6 state-refresh-capable

pim ipv6 timer graft-retry

Syntax
pim ipv6 timer graft-retry interval
undo pim ipv6 timer graft-retry
1-36