Arp Defense Against Ip Packet Attack Configuration Commands; Arp Resolving-Route Enable; Arp Detection Configuration Commands; Arp Detection Enable - 3Com S7906E Command Reference Manual

Table 3-1 display arp source-suppression command output description
Field
ARP source suppression is
enabled
Current suppression limit
Current cache length

ARP Defense Against IP Packet Attack Configuration Commands

arp resolving-route enable

Syntax
arp resolving-route enable
undo arp resolving-route enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the arp resolving-route enable command to enable ARP defense against IP packet attacks.
Use the undo arp resolving-route enable command to disable the function.
By default, the support for ARP defense against IP packet attacks is enabled.
Examples
# Enable ARP defense against IP packet attacks.
<Sysname> system-view
[Sysname] arp resolving-route enable

ARP Detection Configuration Commands

arp detection enable

Syntax
arp detection enable
undo arp detection enable
The ARP source suppression function is enabled
Maximum number of packets with the same source IP address
but unresolvable IP addresses that the device can receive in five
seconds
Size of cache used to record source suppression information
3-3
Description