Set Hello Holddown Timer - 3Com CoreBuilder 7000 Management Manual

C 13: C
398
HAPTER ONFIGURING AND
Set Hello Holddown
Timer
M PNNI (F
ANAGING
Sets the Hello holddown timer value. The Hello holddown timer value is
the value (expressed in milliseconds) used by the specified node to limit
the rate at which it sends Hello packets. A change to the Hello holddown
timer value takes place after the next reboot. For more information on
Hello packets, see "Information Exchange in PNNI" on page 77 in the
Operations Guide.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
interval
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 4 1 5
The following message is displayed:
Default Value is 10 (1 sec), new value is 5
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(2) HHD: Hello Holddown Timer
Format or Range
1 - 30000 milliseconds
1 1 10 4 3 4 2 [parameters]
The Hello holddown timer values is displayed and is
updated to its new value.
Default value is <x>, new value is <y>
)
NLY