Mld-Snooping Version - 3Com S7906E Command Reference Manual

This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
If configured in Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect
only if the interface belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Related commands: subvlan command in IPv6 Multicast VLAN Commands in the IP Multicast Volume.
Examples
# Enable the static router port function on Ethernet 2/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] mld-snooping static-router-port vlan 2

mld-snooping version

Syntax
mld-snooping version version-number
undo mld-snooping version
View
VLAN view
Default Level
2: System level
Parameters
version-number: MLD snooping version, in the range of 1 to 2.
Description
Use the mld-snooping version command to configure the MLD Snooping version.
Use the undo mld-snooping version command to restore the default setting.
By default, the MLD version is 1.
Note that:
This command can take effect only if MLD Snooping is enabled in the VLAN.
This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
Related commands: mld-snooping enable; subvlan in IPv6 Multicast VLAN Commands in the IP
Multicast Volume.
Examples
# Enable MLD Snooping in VLAN 2, and set the MLD Snooping version to version 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
1-23