Pim Ipv6 Hello-Option Dr-Priority - 3Com S7906E Command Reference Manual

View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the pim ipv6 dm command to enable IPv6 PIM-DM.
Use the undo pim ipv6 dm command to disable IPv6 PIM-DM.
By default, IPv6 PIM-DM is disabled.
Note that:
This command can take effect only after IPv6 multicast routing is enabled on the device.
IPv6 PIM-DM cannot be used for IPv6 multicast groups in the IPv6 SSM group range.
Related commands: pim ipv6 sm, ssm-policy; multicast ipv6 routing-table in the IPv6 Multicast
Routing and Forwarding Commands in the IP Multicast Volume.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-DM on VLAN-interface 100.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 dm

pim ipv6 hello-option dr-priority

Syntax
pim ipv6 hello-option dr-priority priority
undo pim ipv6 hello-option dr-priority
View
Interface view
Default Level
2: System level
Parameters
priority: Router priority for DR election, in the range of 0 to 4294967295. A larger value means a higher
priority.
Description
Use the pim ipv6 hello-option dr-priority command to configure the router priority for DR election on
the current interface.
1-30