Igmp-Snooping Query-Interval - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the igmp-snooping querier command to enable the IGMP Snooping querier function.
Use the undo igmp-snooping querier command to disable the IGMP Snooping querier function.
By default, the IGMP Snooping querier function is disabled.
Note that:
This command takes effect only if IGMP Snooping is enabled in the VLAN.
This command does not take effect in a sub-VLAN of a multicast VLAN.
Related commands: igmp-snooping enable; subvlan in Multicast VLAN Commands in the IP
Multicast Volume.
Examples
# Enable IGMP Snooping and the IGMP Snooping querier function in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping querier

igmp-snooping query-interval

Syntax
igmp-snooping query-interval interval
undo igmp-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP general queries, in seconds. The effective range is 2 to 300.
Description
Use the igmp-snooping query-interval command to configure the interval between IGMP general
queries.
Use the undo igmp-snooping query-interval command to restore the default setting.
By default, the IGMP general query interval is 60 seconds.
1-18