Display Interface Tunnel - 3Com S7906E Command Reference Manual

Examples
# Set the interface VLAN-interface 100 (193.101.1.1) of Sysname 1 and the interface VLAN-interface
100 (192.100.1.1) of Sysname 2 as the source and destination interfaces of a tunnel between the two
devices, respectively.
<Sysname1> system-view
[Sysname1] interface tunnel 2/0/0
[Sysname1-Tunnel2/0/0] source 193.101.1.1
[Sysname1-Tunnel2/0/0] destination 192.100.1.1
<Sysname2> system-view
[Sysname2] interface tunnel 2/0/1
[Sysname2-Tunnel2/0/1] source 192.100.1.1
[Sysname2-Tunnel2/0/1] destination 193.101.1.1

display interface tunnel

Syntax
display interface tunnel [ number ]
View
Any view
Default Level
1: Monitor level
Parameters
number: Tunnel interface number. If the number argument is not specified, the information of all tunnel
interfaces will be displayed.
Description
Use the display interface tunnel command to display related information of a specified tunnel
interface, such as source address, destination address, and encapsulation mode.
Related commands: interface tunnel, source, destination, tunnel-protocol.
Examples
# Display the information of the interface tunnel 2/0/0.
<Sysname> display interface tunnel 2/0/0
Tunnel2/0/0 current state: UP
Line protocol current state: UP
Description: Tunnel2/0/0 Interface
The Maximum Transmit Unit is 1476
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 192.13.2.1, destination 192.13.2.2
Tunnel protocol/transport IPv6/IP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
0/100/0
0/500/0
1-2