Destination; Display Ipv6 Interface Tunnel - 3Com S7906E Command Reference Manual

Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
361 packets input,
0 input error
361 packets output,
0 output error
Table 1-1 display interface tunnel command output description
Tunnel2/0/0 current state: UP
Line protocol current state: UP
Description
Tunnel2/0/0 Interface
Maximum Transmit Unit
Encapsulation is TUNNEL
service-loopback-group ID
Tunnel source

destination

Tunnel protocol/transport
Output queue : (Urgent queuing :
Size/Length/Discards)
Output queue : (Protocol queuing :
Size/Length/Discards)
Output queue : (FIFO queuing :
Size/Length/Discards)
Last 300 seconds input
Last 300 seconds output
packets input
input error
packets output
output error

display ipv6 interface tunnel

Syntax
display ipv6 interface tunnel [ number ] [ verbose ]
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
9953388 bytes
30324 bytes
Field
0/75/0
The physical-layer connectivity of the tunnel interface is
established.
The link-layer connectivity of the tunnel interface is
established.
Descriptive information of the tunnel interface
Tunnel interface number
Maximum transmission unit (MTU) in the tunnel
The encapsulation protocol is tunnel.
Service loopback group referenced by the tunnel.
Tunnel source address
Tunnel destination address
Tunnel protocol and transport protocol.
Packet statistics of the urgent queue
Packet statistics of the protocol queue
Packet statistics of the FIFO queue
Number of bytes and packets input per second in the last
five minutes.
Number of bytes and packets output per second in the last
five minutes.
Total number of input packets.
Number of error packets among all input packets.
Total number of output packets.
Number of error packets in all output packets
1-3
Description