3Com S7906E Command Reference Manual page 654

OutFragFails:
InUnknownProtos:
InDelivers:
OutRequests:
OutForwDatagrams:
InNoRoutes:
InTooBigErrors:
OutFragOKs:
OutFragCreates:
InMcastPkts:
InMcastNotMembers:
OutMcastPkts:
InAddrErrors:
InDiscards:
OutDiscards:
Table 1-2 display interface tunnel command output description
Field
Tunnel2/0/0 current state
Line protocol current state
IPv6 is enabled
link-local address
Global unicast address(es)
Joined group address(es)
MTU is 1500 bytes
ND reachable time
ND retransmit interval
Hosts use stateless autoconfig for
addresses
InReceives
InTooShorts
InTruncatedPkts
InHopLimitExceeds
InBadHeaders
InBadOptions
ReasmReqds
0
0
45
45
0
0
0
0
0
0
0
0
0
0
0
The physical-layer state of the tunnel interface
The link-layer protocol state of the tunnel interface
IPv6 forwarding state of the tunnel interface (IPv6 is
enabled on the tunnel interface in this example)
Link-local address of the tunnel interface
Aggregatable global unicast address of the tunnel interface.
Multicast address of the tunnel interface.
Size of the MTU in the tunnel.
Neighbor reachable time
Interval for retransmitting a neighbor discovery request
message.
Hosts use the stateless auto-configuration mode to acquire
IPv6 addresses.
All IPv6 packets received on the tunnel interface, including
error packets.
IPv6 packets that are too short in length received on the
tunnel interface, such as a packet with a length less than 40
bytes.
IPv6 packets received on the tunnel interface, with a length
less than that specified in the packet header.
IPv6 packets having exceeded the hop limit received on the
tunnel interface
IPv6 packets with wrong basic headers received on the
tunnel interface
IPv6 packets with wrong extension headers received on the
tunnel interface
IPv6 fragments received on the tunnel interface
1-5
Description