Description
Use the ipv6 nd ra halt command to enable RA message suppression.
Use the undo ipv6 nd ra halt command to disable RA message suppression.
By default, RA messages are suppressed.
Examples
# Suppress RA messages on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ra halt
ipv6 nd ra interval
Syntax
ipv6 nd ra interval max-interval-value min-interval-value
undo ipv6 nd ra interval
View
Interface view
Default Level
2: System level
Parameters
max-interval-value: Maximum interval for advertising RA messages in seconds, in the range of 4 to
1,800.
min-interval-value: Minimum interval for advertising RA messages in seconds, in the range of 3 to
1,350.
Description
Use the ipv6 nd ra interval command to set the maximum and minimum intervals for advertising RA
messages. The device advertises RA messages at intervals of a random value between the maximum
interval and the minimum interval.
Use the undo ipv6 nd ra interval command to restore the default.
By default, the maximum interval between RA messages is 600 seconds, and the minimum interval is
200 seconds.
Note the following:
The minimum interval should be three-fourths of the maximum interval or less.
The maximum interval for sending RA messages should be less than or equal to the router lifetime
in RA messages.
Examples
# Set the maximum interval for advertising RA messages to 1,000 seconds and the minimum interval to
700 seconds.
<Sysname> system-view
1-31
Need help?
Do you have a question about the S7906E and is the answer not in the manual?