Peer Route-Limit (Mbgp Family View) - 3Com S7906E Command Reference Manual

Description
Use the peer reflect-client command to configure the router as a route reflector and specify a
peer/peer group as a client.
Use the undo peer reflect-client command to remove the configuration.
By default, neither the route reflector nor the client is configured.
Related commands: reflect between-clients and reflect cluster-id.
Examples
# In IPv4 MBGP address family view, configure the local device as a route reflector and specify the
IBGP peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] group test internal
[Sysname-bgp] peer test as-number 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] peer test enable
[Sysname-bgp-af-mul] peer test reflect-client

peer route-limit (MBGP family view)

Syntax
peer { group-name | ip-address } route-limit limit [ percentage ]
undo peer { group-name | ip-address } route-limit
View
IPv4 MBGP address family view
Default Level
2: System level
Parameters
group-name: Name of an IPv4 MBGP peer group, a string of 1 to 47 characters.
ip-address: IP address of an IPv4 MBGP peer.
limit: Upper limit of IP prefixes that can be received from the peer or peer group. Its range and default
value vary with devices.
percentage: If the number of received routes divided by the upper limit reaches the specified
percentage, the system will generate alarm information. The percentage is in the range 1 to 100. The
default is 75.
Description
Use the peer route-limit command to set the maximum number of routes that can be received from a
peer/peer group.
Use the undo peer route-limit command to restore the default.
The number is unlimited by default.
1-43