Peer Enable (Mbgp Family View) - 3Com S7906E Command Reference Manual

route-policy-name: Route policy name, a string of 1 to 19 characters.
Description
Use the peer default-route-advertise command to advertise a default route to a peer/peer group.
Use the undo peer default-route-advertise command to disable default route advertisement to a
peer/peer group.
By default, no default route is advertised to a peer/peer group.
With this command used, the router unconditionally sends a default route with the next hop being itself
to the peer/peer group regardless of whether the default route is available in the routing table.
Examples
# In IPv4 MBGP address family view, advertise a default route to the existing peer group test.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp]group test external
[Sysname-bgp]peer test as-number 200
[Sysname-bgp]ipv4-family multicast
[Sysname-bgp-af-mul] peer test enable
[Sysname-bgp-af-mul] peer test default-route-advertise

peer enable (MBGP family view)

Syntax
peer { group-name | ip-address } enable
undo peer { group-name | ip-address } enable
View
IPv4 MBGP address family view
Default Level
2: System level
Parameters
group-name: Name of an IPv4 MBGP peer group, a string of 1 to 47 characters.
ip-address: IP address of an IPv4 MBGP peer.
Description
Use the peer enable command to enable the specified peer/peer group that has been created in BGP
view.
Use the undo peer enable command to disable the specified peer/peer group that has been created in
BGP view.
If a peer is disabled, the router will not exchange routing information with the peer.
Examples
# Enable the peer 18.10.0.9.
1-36