Igmp-Snooping Static-Router-Port - 3Com S7906E Command Reference Manual

The source-ip source-address option in the command is meaningful only for IGMP Snooping
version 3. If IGMP Snooping version 2 is running, although you can include the source-ip
source-address option in your command, the configuration will not take effect.
If configured in Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect
only if the interface belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this port group that
belong to the specified VLAN.
Examples
# Configure Ethernet 20/1 in VLAN 2 to be a static member port for (1.1.1.1, 232.1.1.1).
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1 vlan 2

igmp-snooping static-router-port

Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be configured, where
vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping static-router-port command to configure the current port(s) as static router
port(s).
Use the undo igmp-snooping static-router-port command to restore the system default.
By default, no ports are static router ports.
Note that:
This command works on both IGMP Snooping–enabled VLANs and VLANs with IGMP enabled on
their VLAN interfaces.
This command does not take effect in a sub-VLAN of a multicast VLAN.
1-22