Peer Timer (Ipv6 Address Family View); Preference (Ipv6 Address Family View) - 3Com S7906E Command Reference Manual

peer timer (IPv6 address family view)

Syntax
peer { ipv6-group-name | ipv6-address } timer keepalive keepalive hold holdtime
undo peer { ipv6-group-name | ipv6-address } timer
View
IPv6 address family view
Default Level
2: System level
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
keepalive: Specifies the keepalive interval in seconds, ranging from 1 to 21845.
holdtime: Specifies the holdtime in seconds, ranging from 3 to 65535.
Description
Use the peer timer command to configure keepalive interval and holdtime interval for a peer or peer
group.
Use the undo peer timer command to restore the default.
keepalive interval defaults to 60 seconds, and holdtime interval defaults to 180 seconds
Note that:
The timer configured with this command is preferred to the timer configured with the timer
command.
The holdtime interval must be at least three times the keepalive interval.
Related commands: timer.
Examples
# Configure the keepalive interval and holdtime interval for the peer group test as 60 seconds and 180
seconds.
<Sysname] system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test timer keepalive 60 hold 180

preference (IPv6 address family view)

Syntax
preference {
route-policy-name }
undo preference
external-preference internal-preference local-preference
1-45
| route-policy