3Com S7906E Command Reference Manual page 945

View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
interface-type interface-number: Specifies an interface.
Description
Use the display ripng interface command to display the interface information of the RIPng process.
If no interface is specified, information about all interfaces of the RIPng process will be displayed.
Examples
# Display the interface information of RIPng process 1.
<Sysname> display ripng 1 interface
Interface-name: Vlan-interface100
Link Local Address: FE80::20F:E2FF:FE30:C16C
Split-horizon: on
MetricIn: 0
Default route: off
Summary address:
Table 1-3 display ripng interface command output description
Field
Interface-name
Link Local Address
Split-horizon
Poison-reverse
MetricIn/MetricOut
Default route
Summary address
3:: 64
3:: 16
Name of an interface running RIPng
Link-local address of an interface running RIPng
Indicates whether the split horizon function is enabled (on: Enabled; off:
Disabled)
Indicates whether the poison reverse function is enabled (on: Enabled;
off: Disabled)
Additional metric to incoming and outgoing routes
Only/Originate: Only means that the interface advertises only the
default route. Originate means that the default route and other RIPng
routes are advertised.
Off indicates that no default route is advertised or the garbage-collect
time expires after the default route advertisement was disabled.
In garbage-collect status: With default route advertisement disabled,
the interface advertises the default route with metric 16 during the
garbage-collect time.
The summarized IPv6 prefix and the summary IPv6 prefix on the interface
Poison-reverse: off
MetricOut: 1
Description
1-5