Ipv6 Neighbor - 3Com S7906E Command Reference Manual

View
Interface view
Default Level
2: System level
Parameters
value: Router lifetime in seconds, in the range of 0 to 9,000. When it is set to 0, the device does not
serve as the default router.
Description
Use the ipv6 nd ra router-lifetime command to configure the router lifetime in RA messages.
Use the undo ipv6 nd ra router-lifetime command to restore the default.
By default, the router lifetime in RA messages is 1,800 seconds.
Note that the router lifetime in RA messages should be greater than or equal to the advertising interval.
Examples
# Set the router lifetime in RA messages on VLAN-interface 100 to 1,000 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ra router-lifetime 1000

ipv6 neighbor

Syntax
ipv6 neighbor ipv6-address mac-address { vlan-id port-type port-number | interface interface-type
interface-number }
undo ipv6 neighbor ipv6-address interface-type interface-number
View
System view
Default Level
2: System level
Parameters
ipv6-address: IPv6 address of the static neighbor entry.
mac-address: MAC address of the static neighbor entry (48 bits long, in the format of H-H-H).
vlan-id: VLAN ID of the static neighbor entry, in the range of 1 to 4094.
port-type port-number: Type and number of a Layer 2 port of the static neighbor entry.
interface interface-type interface-number: Type and number of a Layer 3 interface of the static
neighbor entry.
Description
Use the ipv6 neighbor command to configure a static neighbor entry.
1-33