IPv6 OSPFv3 does not redistribute routes from other protocols by default.
Examples
# Configure to redistribute routes from RIPng and specify the type as type 2 and cost as 50.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] import-route ripng 10 type 2 cost 50
# Configure OSPFv3 process 100 to redistribute the routes found by OSPFv3 process 160.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] import-route ospfv3 160
log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
OSPFv3 view
Default Level
2: System level
Parameters
None
Description
Use the log-peer-change command to enable the logging on neighbor state changes.
Use the undo maximum load-balancing command to disable the logging.
With this feature enabled, information about neighbor state changes of the current OSPFv3 process will
display on the configuration terminal.
Examples
# Disable the logging on neighbor state changes of OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change
maximum load-balancing (OSPFv3 view)
Syntax
maximum load-balancing maximum
undo maximum load-balancing
1-26
Need help?
Do you have a question about the S7906E and is the answer not in the manual?