3Com S7906E Command Reference Manual page 674

View
Any view
Default Level
1: Monitor level
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999.
verbose: Displays detailed routing table information, including that for inactive routes. With this
argument absent, the command displays only brief information about active routes.
Description
Use the display ip routing-table acl command to display information about routes permitted by a
specified basic ACL.
This command is intended for the follow-up display of routing policies.
For more information about routing policy, refer to Routing Policy Configuration in the IP Routing
Volume.
If the specified ACL does not exist or it has no rules configured, the entire routing table is displayed.
Examples
# Define basic ACL 2000 and set the route filtering rules.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] rule deny source any
# Display brief information about active routes permitted by basic ACL 2000.
[Sysname-acl-basic-2000] display ip routing-table acl 2000
Routes Matched by Access list : 2000
Summary Count : 6
Destination/Mask
10.1.1.0/24
10.1.1.2/32
10.1.2.0/24
10.1.2.1/32
10.1.3.0/24
10.1.3.1/32
For detailed description of the above output, see
Proto Pre Cost
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
1-5
NextHop Interface
10.1.1.2 Vlan1
127.0.0.1 InLoop0
10.1.2.1 Vlan2
127.0.0.1 InLoop0
10.1.3.1 Vlan3
127.0.0.1 InLoop0
Table 1-1.