If-Match Extcommunity - 3Com S7906E Command Reference Manual

Parameters
cost: Cost in the range 0 to 4294967295.
Description
Use the if-match cost command to match routing information having the specified cost.
Use the undo if-match cost command to remove the match criterion.
The match criterion is not configured by default.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match tag, route-policy, apply ip-address next-hop, apply cost, apply local-preference, apply
origin, apply tag.
Examples
# Configure node 10 in permit mode of route policy policy1: define an if-match clause to permit routing
information with a cost of 8.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match cost 8

if-match extcommunity

Syntax
if-match extcommunity ext-comm-list-number&<1-16>
undo if-match extcommunity [ ext-comm-list-number&<1-16> ]
View
Route policy view
Default Level
2: System level
Parameters
ext-comm-list-number: Extended community list number, in the range of 1 to 199.
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Description
Use the if-match extcommunity command to specify extended community list(s) for matching against
the extended community attribute of BGP routing information.
Use the undo if-match extcommunity command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 in permit mode of route policy policy1 to match BGP routing information to
extended community lists 100 and 150.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
1-15