3Com S7906E Command Reference Manual page 744

Interface: 192.168.1.2 (Vlan-interface1)
Cost: 1 State: DR
Priority: 1
Designated Router: 192.168.1.2
Backup Designated Router: 192.168.1.1
Timers: Hello 10 , Dead 40 , Poll
Table 1-3 display ospf brief command output description
Field
OSPF Process 1 with Router ID
192.168.1.2
RouterID
Border Router
Route Tag
Multi-VPN-Instance is not enabled
Applications Supported
SPF-schedule-interval
LSA generation interval
LSA arrival interval
Transmit pacing
Default ASE Parameter
Route Preference
ASE Route Preference
SPF Computation count
RFC1583 Compatible
Area Count
Nssa Area Count
ExChange/Loading Neighbors
Area
Authtype
Area flag
SPF scheduled Count
Type: Broadcast MTU: 1500
40 , Retransmit 5 , Transmit Delay 1
OSPF process ID and OSPF router ID
Router ID
Whether the router is a boarder router:
ABR
ASBR
NSSA ABR
The tag of redistributed routes
The OSPF process does not support multi-VPN-instance.
Applications supported.
MPLS Traffic-Engineering means MPLS TE is supported.
Interval for SPF calculations
LSA generation interval
Minimum LSA repeat arrival interval
LSU packet transmit rate of the interface:
Interval indicates the LSU transmit interval of the
interface.
Count indicates the maximum number of LSU packets
sent during each interval.
Default ASE Parameters: metric, tag, route type.
Internal route priority
External route priority
SPF computation count of the OSPF process
Compatible with routing rules defined in RFC1583
Area number of the current process
NSSA area number of the current process
Neighbors in ExChange/Loading state
Area ID in the IP address format
Authentication type of the area:
None: Non-authentication
Simple: simple authentication
MD5: MD5 authentication
The type of the area
SPF calculation count in the OSPF area
1-12
Description