Display Isis Mesh-Group - 3Com S7906E Command Reference Manual

*-Self LSP, +-Self LSP(Extended), ATT-Attached, P-Partition, OL-Overload
Table 1-6 display isis lsdb command output description
Field
LSPID
Seq Num
Checksum
Holdtime
Length
ATT/P/OL
SOURCE
NLPID
AREA ADDR
INTF ADDR
INTF ADDR V6
NBR ID
IP-Internal
IP-External
IP-Extended
COST
HOST NAME
ORG ID
Auth
IPV6
IPV6-Ext

display isis mesh-group

Syntax
display isis mesh-group [ process-id | vpn-instance vpn-instance-name ]
View
Any view
Default Level
1: Monitor level
Link state packet ID
LSP sequence number
LSP checksum
LSP lifetime which decreases as time elapses
LSP length
Attach bit (ATT)
Partition bit (P)
Overload bit (OL)
1 means the bit is set and 0 means the bit is not set.
System ID of the originating router
Network layer protocol the originating router runs
Area address of the originating router
IP address of the originating router's IS-IS interface
IPv6 address of the originating router's IS-ISv6 interface
Neighbor ID of the originating router
Internal IP address and mask of the originating router
External IP address and mask of the originating router
Extended IP address and mask of the originating router
Cost
Dynamic host name of the originating router
Original system ID of the virtual system ID of the originating router
Authentication information of the originating router
Internal IPv6 address and prefix of the originating router
External IPv6 address and prefix of the originating router
1-16
Description