Mld-Snooping Static-Group - 3Com S7906E Command Reference Manual

ipv6-address: Specifies an IPv6 link-local address as the source IPv6 address of MLD
multicast-address-specific queries.
Description
Use the mld-snooping special-query source-ip command to configure the source IPv6 address of
MLD multicast-address-specific queries.
Use the undo mld-snooping special-query source-ip command to restore the default configuration.
By default, the
FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD Snooping is enabled in the VLAN.
Examples
# In VLAN 2, specify FE80:0:0:1::1 as the source IPv6 address of MLD multicast-address-specific
queries.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping special-query source-ip fe80:0:0:1::1

mld-snooping static-group

Syntax
mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping static-group ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Ethernet interface view, Layer 2 aggregate interface view, port group view
Default Level
2: System level
Parameters
ipv6-group-address: Address of a IPv6 multicast group the port(s) will be configured to join as static
member port(s). The effective range is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::),
where x and y represent any hexadecimal number between 0 and F, inclusive.
ipv6-source-address: Address of the IPv6 multicast source the port(s) will be configured to join as static
member port(s).
vlan vlan-id: Specifies the VLAN that comprises the Ethernet port(s), where vlan-id is in the range of 1
to 4094.
Description
Use the mld-snooping static-group command to configure the static IPv6 (*, G) or (S, G) joining
function, namely to configure the port or port group as static IPv6 multicast group or source-group
member(s).
Use the undo mld-snooping static-group command to restore the system default.
By default, no ports are static member ports.
source IPv6 address of MLD multicast-address-specific
1-21
queries is