Reflect Between-Clients (Ipv6 Mbgp Address Family View) - 3Com S7906E Command Reference Manual

Description
Use the preference command to configure preferences for IPv6 multicast eBGP, IPv6 multicast iBGP,
and local IPv6 MBGP routes.
Use the undo preference command to restore the default.
The default preference values of external, internal and local IPv6 MBGP routes are 255, 255, and 130,
respectively.
The greater the preference value is, the lower the preference is.
Examples
# Configure preferences for IPv6 multicast eBGP, IPv6 multicast iBGP, and local IPv6 MBGP routes as
20, 20, and 200.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] preference 20 20 200

reflect between-clients (IPv6 MBGP address family view)

Syntax
reflect between-clients
undo reflect between-clients
View
IPv6 MBGP address family view
Default Level
2: System level
Parameters
None
Description
Use the reflect between-clients command to enable route reflection between clients.
Use the undo reflect between-clients command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to the other clients. If the clients of a
route reflector are fully meshed, you need to disable route reflection between clients to reduce routing
costs.
Related commands: reflector cluster-id and peer reflect-client.
Examples
# Enable route reflection between clients
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv6-family multicast
1-43