Version - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the validate-source-address command to enable the source IP address validation on incoming
RIP routing updates.
Use the undo validate-source-address command to disable the source IP address validation.
The source IP address validation is enabled by default.
Generally, disabling the validation is not recommended.
Examples
# Enable the source IP address validation on incoming messages.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] validate-source-address

version

Syntax
version { 1 | 2 }
undo version
View
RIP view
Default Level
2: System level
Parameters
1: Specifies the RIP version as RIPv1.
2: Specifies the RIP version as RIPv2. RIPv2 messages are multicast.
Description
Use the version command to specify a global RIP version.
Use the undo version command to remove the configured global RIP version.
By default, if an interface has a RIP version specified, the RIP version takes effect; if it has no RIP
version specified, it can send RIPv1 broadcasts, and receive RIPv1 broadcasts, RIPv1 unicasts, RIPv2
broadcasts, RIPv2 multicasts, and RIPv2 unicasts.
Note that:
If an interface has an RIP version specified, the RIP version takes precedence over the global RIP
version.
1-29