Filter-Policy Import (Ospfv3 View) - 3Com S7906E Command Reference Manual

Using the filter-policy export command filters only routes redistributed by the import-route command.
If the import-route command is not configured to redistribute routes from other protocols and other
OSPFv3 processes, use of the filter-policy export command does not take effect.
Examples
# Filter all redistributed routes using IPv6 ACL 2001.
<Sysname> system-view
[Sysname] acl ipv6 number 2001
[Sysname-acl6-basic-2001] rule permit source 2002:1:: 64
[Sysname-acl6-basic-2001] quit
[Sysname] ospfv3
[Sysname-ospfv3-1] filter-policy 2001 export

filter-policy import (OSPFv3 view)

Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } import
undo filter-policy import
View
OSPFv3 view
Default Level
2: System level
Parameters
acl6-number: Specifies an ACL number, ranging from 2000 to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list, a string of up to 19 characters.
Description
Use the filter-policy import command to configure OSPFv3 to filter routes computed from received
LSAs.
Use the undo filter-policy import command to remove the configuration.
By default, OSPFv3 does not filter routes computed from received LSAs.
Using the filter-policy import command only filters routes computed by OSPFv3. The routes that fail to
pass are not added to the routing table.
1-24