Ipv4 Route Policy Configuration Commands; Apply Ip-Address Next-Hop - 3Com S7906E Command Reference Manual

criteria of the node and the apply clauses define the actions to be taken on packets passing the node.
The relation between the if-match clauses of a node is logic AND, namely, all the if-match clauses must
be satisfied. The relation between different route policy nodes is logic OR, namely, a packet passing a
node passes the route policy.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, apply ip-address next-hop, apply local-preference, apply cost, apply
origin, apply tag.
Examples
# Configure node 10 in permit mode of route policy policy1 and enter route policy view.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy]

IPv4 Route Policy Configuration Commands

apply ip-address next-hop

Syntax
apply ip-address next-hop ip-address
undo apply ip-address next-hop
View
Route policy view
Default Level
2: System level
Parameters
ip-address: IP address of the next hop.
Description
Use the apply ip-address next-hop command to set a next hop for IPv4 routing information.
Use the undo apply ip-address next-hop command to remove the clause configuration.
No next hop is set for IPv4 routing information by default.
This command cannot set a next hop for redistributed routes.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, route-policy, apply local-preference, apply cost, apply origin, apply
tag.
Examples
# Configure node 10 in permit mode of route policy policy1 to set next hop 193.1.1.8 for routes
matching AS-PATH list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
1-22